Specifically for the backgeared, open (for workbench mounted motor), square head machine.
In Passion-Usinage's 102N maintenance manual the procedure and drawings refer to the closed head model. The model with the motor in the base. That makes the procedure a little unclear because the part number call-outs in the text do not match the drawing, and the drawing is not quite correct for my headstock version. Part no. 105.26.000
Image may be NSFW.
Clik here to view.
The above drawing is for Part. no 105.27.000
The manual states that the bearings must be lubricated every five years with Kluber Isofix LDS 18 A. The lubrication procedure is given as:
Image may be NSFW.
Clik here to view.
So...
1) Exactly what is this oil of turpentine?
2) How does one lube the countershaft bearings? Is there a trick to non-destructively remove the pressed retainer, part no -26.078?
3) Must the M10x25 screw in the center step of the pulley cone be taken loose? For the backgeared head it is not mentioned in the documentation.
4) Are there any Gotchas with respect to trapped parts, or does the spindle just slide out the nose end once removing the end caps and the center piece (at the back side of the reduction gear housing)?
Have any members here done this procedure?
Thanx
<jbc>
.
In Passion-Usinage's 102N maintenance manual the procedure and drawings refer to the closed head model. The model with the motor in the base. That makes the procedure a little unclear because the part number call-outs in the text do not match the drawing, and the drawing is not quite correct for my headstock version. Part no. 105.26.000
Image may be NSFW.
Clik here to view.
The above drawing is for Part. no 105.27.000
The manual states that the bearings must be lubricated every five years with Kluber Isofix LDS 18 A. The lubrication procedure is given as:
Image may be NSFW.
Clik here to view.
So...
1) Exactly what is this oil of turpentine?
2) How does one lube the countershaft bearings? Is there a trick to non-destructively remove the pressed retainer, part no -26.078?
3) Must the M10x25 screw in the center step of the pulley cone be taken loose? For the backgeared head it is not mentioned in the documentation.
4) Are there any Gotchas with respect to trapped parts, or does the spindle just slide out the nose end once removing the end caps and the center piece (at the back side of the reduction gear housing)?
Have any members here done this procedure?
Thanx
<jbc>
.
