Hi
I decided that when I will be old enough I'll by my self a lathe and a mill and so I did. Because I lack the experience I ask the forum how to align the head stock. I noticed that when I cut to the diameter needed the nearest to the tail stock is larger (0.02mm/on 6cm) in diameter. actually is my conclusion right?
the second question is what is the large handle on top of the headstck (on top the cover) when you pull it some kind of pin gets out and all most disturbs the spindle.
thank's Tal
I decided that when I will be old enough I'll by my self a lathe and a mill and so I did. Because I lack the experience I ask the forum how to align the head stock. I noticed that when I cut to the diameter needed the nearest to the tail stock is larger (0.02mm/on 6cm) in diameter. actually is my conclusion right?
the second question is what is the large handle on top of the headstck (on top the cover) when you pull it some kind of pin gets out and all most disturbs the spindle.
thank's Tal