I have decided to replace all the spindle bearings after nearly forty years hard service of my Matador lathe.
I have about 0.03mm run-out on the spindle taper, I think the spec is 0.01mm when new.
Can someone please advice what size the open cage rollers are for the pulley sleeve and main thrust bearing, items 11 and 18 on the enclosed. Unfortunately this page is missing from my parts manual and I want to get the parts in before I strip the headstock down.
I have the details for the front and rear bearings.
Many thanks Adrian.
I have about 0.03mm run-out on the spindle taper, I think the spec is 0.01mm when new.
Can someone please advice what size the open cage rollers are for the pulley sleeve and main thrust bearing, items 11 and 18 on the enclosed. Unfortunately this page is missing from my parts manual and I want to get the parts in before I strip the headstock down.
I have the details for the front and rear bearings.
Many thanks Adrian.