I am attempting to fix my brake on this lathe--- I was attempting to bleed the caliper when I noticed very little flow coming through.
I pulled the bleed screw out of the caliper and pumped the foot pedal--- I see large chunks of black rubber coming out.
I am ready to disassemble the caliper as I am thinking it might be coming from there, but it could be a seal in the master cylinder too ?
I am ready to pull it all apart but wanted to run it by here , any input is appreciated.
I pulled the bleed screw out of the caliper and pumped the foot pedal--- I see large chunks of black rubber coming out.
I am ready to disassemble the caliper as I am thinking it might be coming from there, but it could be a seal in the master cylinder too ?
I am ready to pull it all apart but wanted to run it by here , any input is appreciated.